How to clean the combined rice mill
After the combined rice mill is used, it must be cleaned, so how to clean the combined rice mill?
1. The body of the cleaning sieve should be flat, intact, running smoothly, and no abnormal noise.
2. Pay attention to check the grain content in the sieve during operation. If there is too much grain, find out the cause and correct it.
3. When the sieve hole is blocked, it is not allowed to hit with iron or hard objects, and the blockage can be removed with a long board brush; the rupture of the screen surface should be repaired or replaced in time.
4. There should be no collision sound during the operation of the fan. After feeding, check the stone, impurities, and stone discharge and impurities in the raw materials. If there is too much grain in the sand, find out the cause and eliminate it.
5. The sieve plate and each air door of the stone remover should be kept unblocked, and the place where the sieve hole is blocked should be cleaned with a wire brush. Do not knock to avoid damage.
6. When adjusting the eccentric rotation mechanism, loosen the rubber pad fastening device, and tighten it after adjustment to make it in a non-prestressed state.
